Note: Fork seals must be in proper working condition, and the proper fork oil level is required for Prime Series Emulators to function. Do not use the product in a bike with blown/bad fork seals. improper fluid levels will result in reduced performance
- Clean the area to avoid getting dirt inside the fork
- Remove any parts that may get in the way when pulling out the spring
- Open only one fork cap if installing with the fork still on the bike
- Pull out the spacer and/or washer along with the spring
- Screw the Prime Emulator into the bottom of the spring
- Slide the spring with the installed emulator back into the fork until you feel it hit the oil
- Note how far down the oil level is from the top of the fork (this will need to be equal in both forks)
- Add fork oil if oil level is lower than the manufacturer’s recommendations
- Place the washer and/or spacer back on top of the spring
- Reinstall the fork cap based on the manufacturer’s recommendation
- Repeat steps 3-8 for the other fork taking care to have the same level of oil in both forks
- Reinstall any remaining parts that came off to get the springs out
- Clean and inspect the motorcycle before riding